Maintenance
66 Servicing and Maintaining Your Empulse
KICKSTAND
Note: Before commencing any work on your Empulse, refer to “SAFETY
PRECAUTIONS”, p a g e 3 6 .
1. Kickstand sensor
2. Kickstand magnet
3. Kickstand spring
Inspection
1. Check that the kickstand assembly is working properly. If the
kickstand is stiff or squeaky, clean the pivot area and lubricate
the pivot pin with clean grease.
2. Check the kickstand spring for damage or loss of tension.
3. Check the kickstand system cut-off:
• Power up the Empulse in drive mode (see “
ENABLING THE DRIVE
SYSTEM”, p a g e 2 0).
• Raise the kickstand. The drive system should be enabled.
• Lower the kickstand. The drive system should be disabled.
Note: If the drive system doesn’t enable with the kickstand up or disable
with the kickstand down, contact your Brammo Authorized Dealer for
service.
Empulse.book Page 66 Thursday, June 27, 2013 11:03 AM
To Next Page
Loading...
