System Warning and Error Codes
84 Taking Care of the Unexpected
S61 SERVICE REQ'D S61 Motor Controller -- Controller in Preoperational Mode
S65 SERVICE REQ'D S65 Motor Controller -- Sequence Fault
(usually, throttle was not closed when controller powered on)
S69 SERVICE REQ'D S69 SYSTEM FAULT S69 Motor Controller -- Entering cutback
S70 SERVICE REQ'D S70 SYSTEM FAULT S70 Motor Controller -- RPDO Timeout (CAN bus timing error)
S71 SERVICE REQ'D S71 SYSTEM FAULT S71 Motor Controller -- Supply Critical
S72 SERVICE REQ'D S72 SYSTEM FAULT S72 Motor Controller -- RPDO Timeout (Severe CAN bus timing error)
S73 SERVICE REQ'D S73 SYSTEM FAULT S73 Motor Controller -- Internal Fault
S77 SERVICE REQ'D S77 SYSTEM FAULT S77 Motor Controller -- Autozero range
S81 SERVICE REQ'D S81 SYSTEM FAULT S81 Motor Controller -- Line Contactor overcurrent
S82 SERVICE REQ'D S82 SYSTEM FAULT S82 Motor Controller -- Line Contactor welded
S83 SERVICE REQ'D S83 SYSTEM FAULT S83 Motor Controller -- Alg In Wire Off (usually, throttle output voltage problem)
S85 SERVICE REQ'D S85 SYSTEM FAULT S85 Motor Controller -- Encoder fault
S86 SERVICE REQ'D S86 SYSTEM FAULT S86 Motor Controller -- Motor over current
S87 SERVICE REQ'D S87 SYSTEM FAULT S87 Motor Controller -- Current Control Fault
S88 SERVICE REQ'D S88 SYSTEM FAULT S88 Motor Controller -- Motor over speed
S94 SERVICE REQ'D S94 SYSTEM FAULT S94 Motor Controller -- Mtr Slv in Wrong State
S96 SERVICE REQ'D S96 SYSTEM FAULT S96 Motor Controller -- DSP Over voltage
S97 SERVICE REQ'D S97 SYSTEM FAULT S97 Motor Controller -- Mosfet s/c M1 Top
Code Message Description
Empulse.book Page 84 Thursday, June 27, 2013 11:03 AM
To Next Page
Loading...
