BRAND HandyStep touch - Battery and Charging Management; Battery Status and Charging

English
5 Functions and controls
HandyStep® touch, HandyStep® touch S 997486
Operating manual
67
NOTICE
>
Charge the battery before the first use or if you have not used the device for an extended time. This
prevents premature wear of the battery.
>
Replace the battery after its service life has been exceeded (~ 3 years), in case of deformation or in
the event of extremely short charging cycles and a resulting shorter duration of use.
>
When storing the device, disconnect the battery plug.
Components
1
2
3
4
1 Battery
2 Contacts
3 Reverse polarity protected plug
4 Cable
Label, rear side
1 Battery type and use
2 Part identification
3 CE marking
4 Warning label
5.3.1 Connecting the battery
A B
C
Open the cover and connect the battery’s reverse polarity protected plug firmly and straight into the
socket. The device switches on when you have connected the battery. Then close the cover.
5.3.2 Charging the battery
a. Connect the cable to the power adapter and HandyS-
tep® touch.
b. Plug the power adapter into the power outlet.
ð
HandyStep® touch is charging.
DOMINIQUE DUTSCHER SAS