English
7 Operation
HandyStep® touch, HandyStep® touch S 997486
Operating manual
73
Modes Description
rated volume into numerous STEPs. See Auto-Dispensing
(AUTO-DISP) ,p.84.
Pipetting In Pipetting mode, a previously selected volume is aspi-
rated once and dispensed again. See Pipetting (PIP),p.86.
Sequential Dispensing (SEQ-DISP) In Sequential Dispensing mode, an aspirated volume is dis-
pensed over several, preset STEPs of varying size. Example
application: dilution series. See Sequential Dispensing
(SEQ-DISP),p.88
Multi-Aspiration (MULTI-ASP) In Multi-Aspiration mode, several STEPs are collected in a
tip and aspirated and dispensed as a total volume. Exam-
ple application: removing residual volumes. See Multi-Aspi-
ration (MULTI-ASP),p.90.
Titration In Titration mode, a volume is aspirated and either quickly
or slowly dispensed. The dispensed volume can be read on
the display. Example application: determining pH values.
See Titration,p.92.
Favorites In Favorites, you can save frequently used settings. You can
reopen these favorites using this menu. See Fa-
vorites,p.95.
7 Operation
WARNING
Possible damage to health caused by pathogenic liquids or infectious germs.
>
Wear appropriate protective gear.
>
When handling the above-mentioned media, please observe the national regula-
tions, safety data sheets, the protection level of your laboratory and safe working
measures.
NOTICE
Device damage caused by incorrect use.
>
Submerge only the tip into a liquid.
>
If the device comes into contact with a liquid, clean it immediately.
>
Hang the device upright in the holder provided.
7.1 Symbol reference
See Symbol reference,p.108.
7.2 Device navigation
See Device navigation,p.108.
To Next Page
Loading...
