BREWART BEERDROID - Keg Filling and Completion; Keg Filling and Level Monitoring; Securing Kegs and Post-Fill Procedures

BEERDROID INSTRUCTIONS
25
 Note
Place a bucket on the floor under
the keg to catch any drips/spill
while kegging.
10. Invert the Keg in the Caddy.
 WARNING
Ensure the Filling Tube is
connected to the Filling cap
before inverting. Some primer
will run into the tube, this is
ok as it will be flushed back
into the keg when filling.
11. Fully open the Tap and
let the keg fill.
 Note
If your BrewDroid was filled to the
10L mark then your first keg is full
when the level reaches the triangle
marker in the window.
12. Turn o the Tap when the level
reaches this mark. Do not overfill.