Brooks LF80C - Page 101

Brooks Automation
278580 Revision A 89
LF80C ZeniD RFID Reader 7 Operation
Product Manual 7.3 Operation of SECS Protocol
Reset acknowledge code
0 … Reset could be done
1 … Reset could not be done
Where used S2F20
Reset code
1… Power-up reset
2 … Software reset
Where used S2F19
Stored SECS message block header. Only the last message is stored, which
must still be confirmed by the host.
Where used S9F9
Software version.
Where used S1F2
RAC Format: B[1]
RIC Format: B[1]
SHEAD Format: B[10]
SOFTREV
Format: A[max
6]