Brooks Automation
80 278580 Revision A
7 Operation LF80C ZeniD RFID Reader
7.3 Operation of SECS Protocol Product Manual
14 Reserved
15 Reserved
16 Reserved
Where used S5F1
For more information on error codes and the corresponding correcting
actions please refer to
Error Codes.
Alarm text
The length of the alarm text is 0 to 40 characters.
According to the reader version, status information about the sensor or
sensors is also transmitted during a reader error message.
The information should be interpreted as follows:
ALTX[0] Initiator of an error message
“0”: Sensor 0
“1”: Sensor 1 (not available)
“F”: Cannot be assigned
ALTX[1] Status of sensor 0
“0”: Sensor not occupied
“1”: Sensor is occupied
“E”: Sensor status is not available
“F”: Sensor not defined
ALTX[2] Status of sensor 1
"0": Sensor not occupied
"1": Sensor is occupied
"E": Sensor state is not available
"F": Sensor not defined
ALTX[3] ‘:’ a colon separates the alarm text from the sensor statuses
Where used S5F1
ALTX
Format:
A[max40]
To Next Page
Loading...
