Polycold Cryochiller
Installation and Operation Manual
Brooks Automation
214072 Revision B
8-1
8 Configuration
About System Configuration
The operation of the Polycold Cryochiller is configurable using the system commands. Some of the
common configuration options and the associated commands are listed in this section.
For clarity, the letter P is used in place of the actual command checksum. See Checksum Calculation
on page 7-4 to determine the actual checksum for a specific command.
For simplicity, only a single sample of command parameters may be shown instead of listing the full set
of command options.
For full list of options for each command, go to the command description in Chapter 7: Host Commands.
To Next Page
Loading...
