What to do if Brooks Chiller has a power failure and the Fault LED is amber?
If your Brooks Chiller experiences a power failure and the Fault LED is amber, the control voltage may be outside acceptable limits. Verify the transformer tap settings to ensure they match your supply voltage. Also, check the supply voltage for deviations beyond the allowable voltage range for the current tap setting.
Details the auto-refrigerating cycle (ARC) cooling process and its advantages.
Explains industry-standard hazard alerts, including text, icons, and signal words.
Covers unauthorized service, proper operation, and seismic restraint precautions.
Addresses hazards like lockout/tagout, mechanical, electrical, thermal, chemical, and pressure.
Covers power input, electrical characteristics, protection, and wiring requirements.
Specifies temperature, flow rate, and purity guidelines for cooling water.
Lists key performance metrics like pumping speed, pressure, and defrost times.
Provides a step-by-step checklist for the entire installation process.
Procedures for checking refrigerant lines for leaks and evacuating the system.
Guides on initial power-up, system checks, and operational modes.
Explains the HMI display, keypad, navigation, and status indicators for unit control.
Explains single and dual circuit modes like Cool, Standby, and Defrost.
Details the compressor safety chain and startup procedures.
Details command structure, parameters, checksum calculation, and response codes for communication.
To Next Page
General