Brother DP-525CJ - 2. LCD Module; 2.1. Disassembling the LCD Module

REPAIR
Mechanical
SERVICE MANUAL
4-8
2. LCD Module
2.1. Disassembling the LCD Module
The LCD unit consists of the LCD upper cover, LCD PCB, LCD lower cover, LCD latch,
and the LCD plate etc.
(1) Remove the LCD unit from the upper cover:
a) Place the upper cover on the table with the LCD screen facing down.
b) Remove the two screws that secure the hinge assy to the upper cover and
remove the hinge assy from the upper cover.
b) Remove the two taptites that secure the LCD bearing to the upper cover and
remove the LCD bearing from the upper cover.
c) Remove the LCD module harness from the LCD bearing by pulling the harness
through the hole in the LCD bearing.
The LCD module can now be removed from the upper cover.
Fig. 4.5 Removing the Core
NOTE:
•
Before disassembling the LCD unit, remove the core that is wound on the cable.