REPAIR
Mechanical
SERVICE MANUAL
4-48
5.3.4.2. Removing the Carriage Drive
(1) Remove the idle pulley holder screw, the idle pulley and the idle pulley holder; to
remove the idle pulley holder, slide it to the right then pull it up.
(2) Remove the CA motor screw, then remove the CA motor by turning the CA motor in
order to disengage the CA motor flange from the hook on the CA frame.
NOTE:
•
After reassembling the timing belt and the motor, it is necessary to adjust the carriage
home position and check the carriage belt tension. See 5.4.1. “Adjusting the Carriage
Home Position” and 5.4.2. “Adjusting Belt Tension”.
Fig. 4.39 Removing the Carriage Drive
To Next Page
Loading...
