Brother DP-525CJ - Fig. 4.16 Installing the LCD Lower Cover

REPAIR
Mechanical
SERVICE MANUAL
4-22
<DP-540CJ, DP-550CJ/LW-840ic>
Adjust the position of the LCD PCB by aligning the holes in the LCD PCB with
the bosses on the LCD upper cover. Tighten the screws to secure the LCD
PCB in place.
c) Return the LCD harness to its original position
(3) Install the LCD lower cover:
a) Place the LCD lower cover on the LCD upper cover.
b) Place the assembly of the LCD lower cover and upper cover on the table with
the LCD screen facing up.
c) Tighten the screw (1 pc) and taptites (7 pcs.) to clamp the LCD lower cover to
the LCD upper cover.
d) Fit the LCD spacer M (1 pc.) and LCD spacer LR (2 pcs.) to the LCD upper
cover.
e) Fit the LCD rubber LR (2 pcs.) to the LCD upper cover.
Fig. 4.16 Installing the LCD Lower Cover