Brother HL-2060 - Page 125

VII-12
To transfer the data of dot matrix
printers coming through MIO to
RS-232C.
Print the data on the printer.
This is chosen by default.
Pass the data through RS-232C to
print it out on a dot matrix printer.
Switch the emulation to the PS
mode when AppleTalk receives
data.
This is chosen by default.
The auto emulation function
switches emulations
Rotate the fun when a printer is in
ready status
This is chosen by default.
Reverse ON/OFF when a printer is
in ready status.
Not rotate the fun when a printer is
in ready status.
The fan rotates at low speed when
a printer is in ready status.
This is chosen by default.
The fan rotates at high speed
when a printer is in ready status.
Set the time to turn ON the fan in
the range from 0 sec. to 3600 sec.,
by 15 sec.
Set the time to turn OFF the fan in
the range from 0 sec. to 3600 sec.,
by 15 sec.
Rotate the fan when a printer is in
the sleep mode.
BYPASS MODE SEL
BYPASS MODE=OFF
BYPASS MODE=ON
APPLETALK AT/PS
APPLE TALK=PS
APPLE TALK=AUTO
SW = ON
FAN CONTROL SWITCH
SW = ON/OFF
SW = OFF
SPEED = SLOW
SPEED
SPEED = HIGH
ONTIME
FAN ON = 0S
OFFTIME
FAN OFF = 0S
SW = ON
SWITCH (S)