VII-13
Reverse ON/OFF when a printer is
in the sleep mode.
Not rotate the fan when a printer is
in the sleep mode.
This is chosen by default.
The fan rotates at low speed when
a printer is in the sleep mode.
This is chosen by default.
The fan rotates at high speed
when a printer is in the sleep
mode.
Set the time to turn ON the fan in
the range from 0 sec. to 3600 sec.,
by 15 sec.
Set the time to turn OFF the fan in
the range from 0 sec. to 3600 sec.,
by 15 sec.
Set the time between when MP
tray sensor senses paper and
starting to feed. The value can be
selected in the range from 0 msec.
to 2000 msec., by 100 msec.
This is chosen by default.
Flash card test mode
Flash card test mode
Set the first print speed.
Not rotate a laser unit at power on
for the less of laser unit noise.
This is chosen by default.
Rotate a laser unit at power on.
The first print time will reduced.
SW = ON/OFF
SW = OFF
SPEED = SLOW
SPEED (S)
SPEED = HIGH
ONTIME (S)
FAN ON = 0S
OFFTIME (S)
FAN OFF = 0S
MP FEED TIME
MP FEED=500msec
FLASH CARD CHECK
FLASH CARD CHK2
SPEED=NORMAL
FIRST PRINT
SPEED=MIDDLE
To Next Page
Loading...
