Brother HL-2060 - Page 127

VII-14
Always keep a laser unit rotating.
The first print time will be reduced
by 2 sec.
*As the laser unit life is 3000h, it
would necessary to replace the
laser unit periodically.
Adjust the interval of the paper
feeding
A4 size paper is fed with an
interval to achieve 20ppm print
speed. This is chosen by default.
Countermeasure of the print quality
problem which is likely appear as it
is high humidity.
This is chosen by default.
Change the handling of data which
comes in through CDCC and RS-
232C.
Handle the data as ASCII.
Cntl-T, Cntl-C etc. are handled as
the control codes
This is chosen by default.
Binary data can be printed.
Cntl-T, Cntl-C etc. does not work.
Not accept the binary data even
with special codes.
This is chosen by default.
Accept the binary data with special
codes.
This setting is for the faster print
speed with a OS/2 driver.
This is chosen by default.
PS BINARY=BIN
SPEED=HIGH
SPEED=20.0ppm
PRINT SPEED
SPEED=21.0ppm
HUMIDITY=LOW
HUMIDITY
HUMIDITY=HIGH
PS BINARY=ASCII
PS BINARY SELECT
PS QUOTEBIN=ON
PS QUOTE BINARY
PS QUOTEBIN=ON
PS IMAGEMSK=OFF
PS IMAGE MASK
PS IMAGEMSK=ON