Brother HL-2060 - Page 128

VII-15
To support Windows 95 Plug &
Play.
This is chosen by default.
Not use the ranlength
decompression.
This is chosen by default.
Use the ranlength decompression
on software side.
To support some MIO with a
firmware download function and
unknown timeout for restarting.
Restart MIO after the 10 min.-
timeout.
This is chosen by default.
Some UNIX systems leave a
printer with MIO in open
connection and do not put it close
connection. Due to this, the data
received by the other interfaces is
not processed.
Even if a printer stays in open
connection, it is able to process
the data received by parallel and
serial I/F.This is chosen by default.
Process 2 pages data at a time.
Process 4 pages data at a time.
This is chosen by default.
Set PJL JOB TIMEOUT (5 min.)
ON/OFF.
PJL JOB TIMEOUT is effective.
This is chosen by default.
PJL JOB TIMEOUT does not carry
out.
BOISE ID=WIN95
BOISE ID MODE
BOISE ID=IEEE
ECP RLE = OFF
ECP RLE MODE
ECP RLE = ON
MIO RESTART = OFF
MIO RESTART MODE
MIO RESTART = ON
MIO TIMEOUT MODE
MIO TIMEOUT = OFF
MIO TIMEOUT = ON
DPX MODE = SLOW
DPX MODE
DPX MODE = FAST
TIME OUT=ON
JOB TIMEOUT SEL
TIME OUT=OFF