Brother HL-2060 - Page 72

IV-25
(5) Rremove the Thermistor lead wire connector (2P) of the Fixing PCB (see Figure
4.51).
(6) Detach the wire from the hooks of the Fixing unit chassis.
(7) Loosen 4 screws and remove the Fixing unit cover.
Note: When removing the Fixing unit cover, the Thermistor cleaner ASSY and the spring
come off from the Fixing unit cover. Insert the Thermistor cleaner ASSY together
with the spring into the correct possition first, and start reassembling. See Figure
4.50b.
Figure 4.51
Figure 4.52
Screws
Fixing unit chassis
Fixing unit cover
Hooks
Screws
Thermistor cleaner ASSY
Spring