Brother HL-4040CN - Page 105

Control panel setup
98
10
(HL-4070CDW) 10
See (HL-4040CN / HL-4050CDN) on page 97 for the HL-4040CN / HL-4050CDN LAN menu table.
Level one Level two Level three Level four Options
LAN Wired TCP/IP BOOT Method Auto*, Static, RARP, BOOTP, DHCP
IP Address [000-255].[000-255].[000-255].[000-
255]
[000].[000].[000].[000] *
1
Subnet Mask [000-255].[000-255].[000-255].[000-
255]
[000].[000].[000].[000] *
1
Gateway [000-255].[000-255].[000-255].[000-
255]
[000].[000].[000].[000] *
IP Boot Tries 0 to 32767
3*
APIPA On*, Off
IPv6 On, Off*
Ethernet Auto*, 100B-FD, 100B-HD, 10B-FD, 10B-HD
Set to
Default
OK? -
Wired Enable On*, Off -
WLAN TCP/IP BOOT Method Auto*, Static, RARP, BOOTP, DHCP
IP Address [000-255].[000-255].[000-255].[000-
255]
[000].[000].[000].[000] *
1
Subnet Mask [000-255].[000-255].[000-255].[000-
255]
[000].[000].[000].[000] *
1
Gateway [000-255].[000-255].[000-255].[000-
255]
[000].[000].[000].[000] *
IP Boot Tries 0 to 32767
3*
APIPA On*, Off
IPv6 On, Off*
Setup WLAN Setup Wizard See Using the Setup Wizard from the control
panel on page 25.
SecureEasySetu
p
Configuration using
SecureEasySetup™. on page 19.