Brother HL-4040CN - Page 110

Control panel setup
103
10
f Press back.
 Signal
This field displays the current wireless network signal strength; Strong, Medium, Weak or None.
a Press the + or - button to select LAN. Press OK.
b Press the + or - button to select WLAN. Press OK.
c Press the + or - button to select WLAN Status. Press OK.
d Press the + or - button to select Signal. Press OK.
e The current wireless network signal strength will be displayed; Strong, Medium, Weak or None.
f Press back.
Note
This menu only appears when Status is Active (11b)or Active (11g) for the wireless network.
 SSID
This field displays the current wireless network SSID.
a Press the + or - button to select LAN. Press OK.
b Press the + or - button to select WLAN. Press OK.
c Press the + or - button to select WLAN Status. Press OK.
d Press the + or - button to select SSID. Press OK.
e The current wireless network SSID will be displayed.
f Press back.
Note
This menu only appears when Status is Active (11b)or Active (11g) for the wireless network.
 Comm. Mode
This field displays the current wireless network communication mode; Ad-hoc or Infrastructure.
a Press the + or - button to select LAN. Press OK.
b Press the + or - button to select WLAN. Press OK.
c Press the + or - button to select WLAN Status. Press OK.
d Press the + or - button to select Comm. Mode. Press OK.
e The current wireless network communication mode will be displayed; Ad-hoc or Infrastructure.