Configuring your printer for a network with an Ethernet cable connection
13
2
c Double-click the unconfigured device.
Note
• If the print server is set to its factory default settings without using a DHCP/BOOTP/RARP server, the
device will appear as Unconfigured in the BRAdmin Light utility screen.
• You can find the node name and Ethernet address by printing out the Printer Settings Page. See Printing
the Printer Settings Page on page 105.
d Choose Static from Boot Method. Enter the IP address, Subnet Mask and Gateway (if needed) of
your print server.
e Click OK.
f With the correctly programmed IP address, you will see the Brother print server in the device list.
Windows
®
Macintosh
®
Windows
®
Macintosh
®
To Next Page
Loading...
