Wireless configuration for Windows
®
using the Brother automatic installer application
35
4
8 Press OK.
If the following message appears, press OK again.
WLAN Enable?
On
Note
The message above only appears when the wireless setting is disable.
9 The wireless network connection status using the SecureEasySetup™ software will be displayed;
Connecting WLAN, Connected or Connection NG.
Connecting WLAN is displayed when the print server is trying to make connections to your router
or access point. Wait till either Connected or Connection NG is displayed.
Connected is displayed when the print server is successfully connected to your router or access
point. You can now use your printer in a wireless network.
Connection NG is displayed when the print server has not successfully connected to your router
or access point. Try starting from a again. If the same message is displayed again, reset the print
server back to the default factory settings and try again.
Note
If the LCD shows Connection NG, please try again.
l Click Finish.
m The configuration is finished. Relocate the printer to a location that is within range of your access point.
You have completed the wireless setup. If you chose to install the printer driver in step g, Go
to Installing the printer driver on page 56.
To Next Page
Loading...
