Wireless configuration for Windows
®
using the Brother automatic installer application
55
4
q Click Next. The settings will be sent to your printer. The settings will remain unchanged if you click
Cancel.
Note
If you want to manually enter the IP address settings of your printer, click Change IP Address and enter
the necessary IP address settings for your network. After making your selection, click Next and the Wizard
will search for available wireless networks.
r To communicate with the configured wireless device, you must configure your computer to use same
wireless settings. Manually change the wireless settings on your computer to match the printer’s wireless
settings shown on this screen. Check the box if you confirm, and then click Next.
(The settings shown on this screen are for example only. Your settings will not be the same.)
You have completed the wireless setup. If you chose to install the printer driver in step e, Go
to Installing the printer driver on page 56.
To Next Page
Loading...
