Wireless configuration for Macintosh
®
using the Brother automatic installer application
78
5
Note
You can temporarily change the wireless settings on your computer, following the steps below:
1 Click the AirPort status icon and select Open Internet Connect....
2 Click the Network tab to see the available wireless devices. You can see the Brother wireless print
server in the Network option. Select SETUP.
3 Your wireless network is connected successfully.
l If more than one wireless printer is available on the network, the following list appears. If the list is blank,
check if the access point and the printer are powered on, and then click Refresh. Choose the printer you
wish to configure, and click Next.
Note
The default Node name is “BRNxxxxxx” for the users that temporary connect with a network cable, or
“BRWxxxxxx” for the users that connect without a network cable (where “xxxxxx” are the last six digits of
Ethernet address).
m The wizard will search for wireless networks available from your printer. Choose the Ad-hoc network you
wish to associate the printer with, and then click Next.
If no Ad-hoc wireless networks are available, you need to create a new wireless network. Go to p.
To Next Page
Loading...
