Brother HL-4200CN - Latch R; Sensor TNR Full

- IV-35 -
2.3.21 Sensor TNR full
1) Release the 2 hooks securing the sensor TNR full to the chute ASSY IN.
2) Remove the connector on the sensor TNR full.
3) Remove the sensor TNR full from the chute ASSY IN.
Fig.4-61
2.3.22 Latch R
1) Release the hook at the lower part of the spring latch securing it to the hole on the
right side of the chute ASSY IN.
2) Release the hook securing the latch R to the chute ASSY IN.
3) Pull out the latch R from the chute ASSY IN together with the shaft latch and the
spring latch.
4) Remove the spring latch from the latch R.
5) Pull out the shaft latch from the latch R.
Fig.4-62
Sensor TNR full
Front
Chute ASSY IN
Shaft latch
Latch R
Spring latch