Brother HL-4200CN - Actuator REGI; Sensor Photo: REGI

- IV-38 -
2.3.26 Actuator REGI
1) Holding the shielding portion of the actuator REGI move the actuator REGI left and
extract the right hand end of the shaft of the actuator REGI from the bush of the
chute ASSY REGI.
2) Pull out the actuator REGI from the chute ASSY REGI together with the spring
sensor REGI.
3) Remove the spring sensor REGI from the actuator REGI.
Fig.4-67
2.3.27 Sensor photo: REGI
1) Release the 3 hooks securing the sensor photo: REGI to the chute ASSY REGI.
2) Remove the sensor photo: REGI from the chute ASSY REGI.
3) Remove the connector from the sensor photo: REGI.
Fig.4-68
Spring sensor REGI
Chute ASSY REGI
Chute ASSY REGI
Sensor photo: REGI
Top
Front
A
ctuato
r
REGI