I-9
*3: Fan status is changed depending on the state (temperature, etc.) of the fixing
system.
8.7 Process Speed
The printer prints by switching two levels, Full speed (printing with the highest process
speed of the printer) and Half speed (printing with the half of process speed). The
controller cannot instruct to change the process speed.
8.8 Print Mode
The printer has four modes, Standard mode, Fine mode, High gloss mode, and Super
high gloss mode. Modes are switched over under the instruction from the controller.
(1) Standard mode: used for printing with resolution 600dpi
(2) Fine mode: process direction resolution 1200dpi mode
(3) High gloss mode: thick paper, special paper, and high glossed plain paper
(4) Super high gloss mode: thick paper, special paper, and super high glossed plain
paper
To Next Page
Loading...
