Brother HL-4200CN - Lvps

- IV-61 -
Note:
When replacing the link lever: R, align the spring IDT R and the bottom of link lever: L
with the positions shown in the figure (lever drum: L replacement).
Fig.4-109
2.5.9 LVPS
1) Remove the three connectors from the LVPS.
2) Remove the clamp guide harness.
3) Remove the harness from the guide harness SW.
Fig.4-110
Link lever: R
Gear IDL. press
Gear press R
Clamp guide harness
Guide harness SW
Clamp guide harness
Harness