- IV-62 -
4) Releasing the hooks at 2 positions, and then remove the guide harness SW.
5) Remove the screw, and then release the ground wire.
6) Disconnect the connector on the guide harness SW.
7) Remove the switch part of the guide harness SW.
8) Releasing the hooks at 2 positions, and then remove the inlet part of the guide
harness SW.
9) Remove the guide harness SW.
Fig.4-111
10) Remove 3 screws securing the LVPS STD to the printer.
11) Remove the LVPS STD from the printer.
Fig.4-112
LVPS
Screw, M3x6
Screw, M3x10
Screw, M3x6
Guide harness SW
Switch part
Guide harness SW
Inlet part
Connector
Ground wire
To Next Page
Loading...
