- IV-56 -
4) Remove the link lever: L from the printer together with the spring lever: 30N and
lever drum: L.
5) Remove 4 springs from link lever: L and remove 4 lever drum: L.
Note:
When replacing the link lever, align the spring IDT L and the bottom of link lever: L with
the positions shown in the figure (lever drum: L replacement).
Fig.4-101
Note:
The lever drum: L and link lever: L must be fitted and aligned before refitting spring lever
30N.
Fig.4-102
Gear IDL. press
Gear press L
Link lever: L
Lever drum: L
Gear IDL. press
Gear press L
Link lever: L
To Next Page
Loading...
