APPENDIX 1
1.1 When PCB is replaced
The information below is stored in NV-RAM (EEPROM) on ESS.
If necessary, transfer the data to a new PCB.
- U8 (Part number)
1. Data set with Control Panel
2. NV-RAM data on MCU that is saved manually
3. Error Log
4. Jam Log
5. Billing Counter
- U9 (Part number)
The information stored is specific to the Controller Board, therefore, the
information cannot be used for the new PCB.
- U7/U38 (Part number)
Job Log is stored, however, the Job Log cannot be transferred to the new PCB
because it is surface-mounted.
The Network setting data is stored in EEPROM on NIC EXCORD ASSY. Use the
same NIC EXCORD ASSY if you want to keep the same Network setting.
To Next Page
Loading...
