Chapter 3
20
Real Time Transmission 3
When you are sending a fax, the machine will
scan the documents into the memory before
sending it. Then, as soon as the telephone
line is free, the machine will start dialing and
sending.
Sometimes, you may want to send an
important document immediately, without
waiting for memory transmission. You can set
Real Time TX to On for all documents or
Next Fax:On for the next fax only.
• If the memory is full and you are sending a
fax from the ADF, the machine will send
the document in real time (even if
Real Time TX is set to Off). If the memory
is full, faxes from the scanner glass cannot
be sent until you clear some of the
memory.
• In Real Time Transmission, the automatic
redial feature does not work when using
the scanner glass.
Sending in real time for all faxes 3
a Make sure you are in FAX mode .
b Press Menu, 2, 2, 5.
22.Setup Send
5.Real Time TX
a On
b Off
Select ab or OK
c Press a or b to choose On (or Off).
Press OK.
Sending in real time for the next fax
only 3
a Make sure you are in FAX mode .
b Press Menu, 2, 2, 5.
22.Setup Send
5.Real Time TX
a On
b Off
Select ab or OK
c Press a or b to choose Next Fax:On
(or Next Fax:Off).
Press OK.
Overseas Mode 3
If you are having difficulty sending a fax
overseas due to a bad connection, then
turning on Overseas Mode may help.
This is a temporary setting, and will only be
active for your next fax.
a Make sure you are in FAX mode .
b Load your document.
c Press Menu, 2, 2, 8.
22.Setup Send
8.Overseas Mode
a On
b Off
Select ab or OK
d Press a or b to choose On or Off.
Press OK.
To Next Page
Loading...
Need help?
General
