Brother MFC-8690DW - Using the SES;WPS or AOSS Control Panel Menu to Configure Your Machine for a Wireless Network (Automatic Wireless Mode)

Configuring your machine for a wireless network (For MFC-8690DW and MFC-8890DW)
36
3
Using the SES/WPS or AOSS™ control panel menu to configure your machine
for a wireless network (Automatic Wireless mode) 3
If your wireless access point/router supports either SecureEasySetup™, Wi-Fi Protected Setup (PBC
1
) or
AOSS™, you can configure the machine easily without knowing your wireless network settings. Your Brother
machine has the SES/WPS/AOSS™ menu on the control panel. This feature automatically detects which
mode your access point uses, SecureEasySetup™, Wi-Fi Protected Setup or AOSS™. By pushing a button
on the wireless access point/router and the machine, you can setup the wireless network and security
settings. See the user’s guide for your wireless access point/router for instructions on how to access
one-push mode.
1
Push Button Configuration
Note
Routers or access points that support SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ have the
symbols shown below.
a Plug the machine’s power cord into the AC power outlet. Turn on the machine’s power switch.
b Press Menu, 7, 2, 7. Using a or b, choose On and press OK.
Press Stop/Exit.
72.WLAN
7.WLAN Enable
a On
b Off
Select ab or OK
c Press Menu, 7, 2, 3 for SES/WPS/AOSS.
This feature will automatically detect which mode (SecureEasySetup™, Wi-Fi Protected Setup or
AOSS™) your access point uses to configure your machine.
Note
If your wireless access point supports Wi-Fi Protected Setup (PIN Method) and you want to configure your
machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi
Protected Setup on page 39.
For MFC-8890DW only.