Brother MFC-8690DW - Configuration in Ad-hoc mode

Wireless configuration for Windows
®
using the Brother installer application (For MFC-8690DW and MFC-8890DW)
45
4
h Connect the Brother wireless device to your access point using a network cable and click Next.
i Choose the machine you wish to configure, and click Next. If the list is blank, check if the access point
and the machine are powered on, and then click Refresh.
Note
• The default Node name is “BRNxxxxxxxxxxxx”. (“xxxxxxxxxxxx” is your machine’s MAC Address /
Ethernet Address.)
• You can find your machine’s MAC Address / Ethernet Address by printing out the Network Configuration
List. See Printing the Network Configuration List on page 123.