Brother MFC-9420CN - Set Your Country (for Australia; New Zealand Customer Only); Setting the Date and Time

9
Setting Up
the machine
Windows
®
USB
Windows
®
Parallel
Windows
NT
®
4.0
Parallel
Macintosh
®
USB
Macintosh
®
Network
Windows
®
Network
For
Network Users
You must set your country so that the machine
works correctly on local telecommunication lines
in each country.
1
Check that the power is turned on by
plugging in the power cord and turn the
power switch on.
Press Menu/Set.
2
Press or to select the country
(AUSTRALIA or NEWZEALAND).
Press Menu/Set when the LCD shows your
country.
3
The LCD prompts you to make sure of the
country again.
4
If the LCD shows the correct country, press
1 to go to Step
5
.
—OR—
Press 2 to go back to Step
1
to select the
country again.
5
After the LCD shows
Accepted
for two
seconds, it shows
Please Wait
.
The machine displays the date and time, and prints it
on every fax you send.
1
Press Menu/Set.
2
Press 0.
3
Press 2.
4
Enter the last two digits of the year on the
dial pad, and then press Menu/Set.
(e.g. Enter 0, 5 for 2005.)
5
Enter the two digits for the month on the dial
pad, and then press Menu/Set.
(e.g. Enter 0, 3 for March)
6
Enter the two digits for the day on the dial
pad, and then press Menu/Set.
(e.g. Enter 0, 1.)
7
Enter the time in 24-hour format on the dial
pad, and then press Menu/Set.
(e.g. Enter 1, 5, 2, 5 for 3:25 P.M.)
8
Press Stop/Exit.
6
Set Your Country
(For Australia / New
Zealand Customer Only)
Set Country
Press Set Key
Australia
Select
▲▼
& Set
Australia?
1.Yes 2.No
Australia?
Accepted
7 Setting the Date and Time
Date/Time
Year:2005
Date/Time
Month:03
Date/Time
Day:01
Date/Time
Time:15:25
If you make a mistake, press Stop/Exit to
start from Step
1
.