4
Setting Up the machine
Do NOT connect the interface cable.
Connecting the interface cable is
done during the software
installation process.
1
Remove the protective tape.
2
Open the front cover.
3
Remove the protective part.
4
Take out all four toner cartridges from the
machine.
5
Carefully pull the red protective paper out of
the machine.
Ensure the laser glass cover is down.
6
Rock the toner cartridge 3 to 4 times.
7
Pull off the tape labelled REMOVE, and
then remove the orange protective cover.
1
Install the Toner
cartridges
Front cover
REMOVE tape Protective cover
Go to the next page
Step 1
To Next Page
Loading...
