Brother NS-10 - Assembly of Selecting Panel H Assy. (Attachment of Selecting Dial)

3 - 34
Main parts
Main unit
Assembly
2-2 Assembly of Selecting panel H assy. (Attachment of Selecting dial)
1. Attach the dial roller guide 1 to the selecting panel H assy. 2.
*Key point
• Check that the hook 3 hang on it.
2. Attach the selecting dial 4 to the selecting panel H assy. 2.
3. Attach the dial spring 5 to the selecting panel H assy. 2.
4. Insert the pattern selecting roller 7 into the pattern selecting shaft 6, and
then attach it to the selecting panel H assy. 2.
*Key point
• Check that the selecting roller 7 engaged with the positioning
hole 8 of the dial spring 5.
5. Attach the indication sheet ; to the selecting shutter 9.
*Key point
• Check that the boss part A of the selecting shutter 9
engaged with the positioning hole B of the indication sheet 0.
6. Attach the selecting shutter 9 to the selecting panel H assy. 2.
*Key point
• Check that the protrusion C of the selecting dial 4 engaged
with the groove D of the selecting shutter 9.
7. Attach the selecting shutter 9 to the selecting dial 4 with the screw 1.
Apply the silicon grease to the inside side of the
tip protrusion A of the dial roller guide.
Thinly all
surface
Apply the silicon grease to all around the section
B of the back side of the selecting panel.
Thinly all
surface
1
Torque
0.39 – 0.78 N·m
A
2
1
2
4
8 6 5
72
C 0
A
D
9
9 1
4 B
B
3
Taptite, Bind B
M3X8