Brother NS-10 - Attachment of Presser Foot Lifter

3 - 47
Needle-presser module
Modules
9 Attachment of Presser foot lifter
1. Attach the presser foot lifter 1 to the shaft 2 of the base holder assy., and
then attach the retaining ring E4.
*Key point
• Push the presser bar clamp 3 to the upper side, and then
attach it while pushing the bottom side of the thread release
lever 4.
Apply EPNOC AP (N) 0 to the shaft of the base
holder assy.
Small amount
XC8387***
Apply EPNOC AP (N) 0 to the operating surface of
the presser bar lifter presser bar clamp.
Small amount
XC8387***
3
2
1
4
Retaining ring E4
10 Attachment of PF switch assy.
1. Attach the PF switch assy. 1 to the presser switch holder 2.
*Key point
• Check that the boss part of the PF switch assy. 1 align the
positioning hole of the presser switch holder 2.
2. Attach the presser switch holder 2 to the base holder assy. with the screw
1.
*Key point
• Check that the boss part of the PF switch assy. 1 align the
notch part of the base holder assy.
1
Torque
0.78 – 1.18 N·m
2
1
1 1
Screw, Bind
M3X6