Brother NS-10 - Removal of Timing Pulley D

2 - 51
Feed and bobbin module
Modules
Disassembly
15 Removal of Timing pulley D
1. Remove the 2 screws 1, and then remove the timing pulley D 1 from the
lower shaft assy. 2.
2
1
1
16 Removal of Lower shaft bushing
1. Remove the retaining ring E6, and then lower shaft bushing 1 from the
lower shaft assy. 2.
2
Retaining ring E6
1
17 Removal of Bushing presser B
1. Remove the retaining ring E6, and then remove the “washer, thrust 2”
from the lower shaft assy. 1.
2. Remove the 3 screws 1, and then remove the bushing presser B 3 from
the base plate assy.
3. Remove the lower shaft bushing 4 and the “washer, thrust 5” from the
lower shaft assy. 1.
21
1 1
3
Retaining ring E6
5 1
4