Brother NS-10 - Removal of Bushing Presser (for Upper Shaft)

2 - 30
Needle bar, presser mechanism / Upper shaft mechanism
Main unit
1 Removal of Bushing presser (For upper shaft)
1. Remove the 2 screws 1, and then remove the 2 bushing pressers 1 from
the arm bed.
11
1 1
2 Removal of Upper shaft assy.
1. Remove the screw 1.
2. Remove the upper shaft assy. 1.
*Key point
• Remove the thread take-up counter weight 2 from the needle
bar crank rod assy. 3 while drawing out the upper shaft assy.
1.
3. Remove the T belt 4 from the upper shaft assy. 1.
4. Remove the pulley 5 from the upper shaft assy. 1.
3 1 2
1 5
4
3 Removal of Coaching clip
1. Cut the band 1.
2. Remove the screw 1, and then remove the coaching clip 2 and the
insulator sheet 3.
1
1 2
3