Brother NS-10 - Bobbin Winder Mechanism; Attachment of Bobbin Winder Assy

3 - 14
Bobbin winder mechanism
Main unit
1 Attachment of Bobbin winder assy.
1. Attach the bobbin winder assy. 1 to the arm bed with the 2 screws 1.
1
Torque
1.47 – 1.96 N·m
1
1
Taptite, Bind S
M4X10
1-1 Assembly of Bobbin winder assy. (Attachment of SW adjust plate)
1. Align the boss part of the SW adjust plate 1 with the positioning hole of
the bobbin winder assy. holder 2, and then tighten the screw 1
temporarily.
*Key point
• Fully tighten the screw after performing "4-19 Adjustment of
BW switch position".
1
Torque
0.59 – 0.78 N·m
1
1
2
Screw, Bind
M3X6
1-2 Assembly of Bobbin winder assy. (Attachment of Bobbin winder shaft stopper)
1. Align the boss part of the bobbin winder shaft stopper 1 with the
positioning hole of the bobbin winder assy. holder 2 with the screw 1.
1
Torque
0.78 – 1.18N·m
1
1
2
Screw, Bind
M3X6