Brother NS-10 - Attachment of Feed Bar

3 - 62
Feed and bobbin module
Modules
Assembly
13 Attachment of Feed bar
1. Insert the polyester slider 2, the feed bar 3 and the polyester 4 into the
feed arm A assy. 1, and then attach the retaining ring CS4.
*Key point
• Check that the vertical adjusting screw 5 engaged with the
groove of the vertical lever 6.
• Check that there should no gap between the retaining ring
CS4 and the feed bar 3.
Apply EPNOC AP (N) 0 to the feed shaft hole in
the feed bar.
Bead
XC8387***
Apply EPNOC AP (N) 0 to the feed arm A assy.
Bead
XC8387***
Apply EPNOC AP (N) 0 to the groove of the
vertical lever.
Small amount
XC8387***
3
1
Retaining ring CS4
2
4
6
5
14 Attachment of Spring
1. Attach the spring to the feed bar 1 and the base plate assy. 2.
S13
S13
2
1
S13
SPRING
XE1940***
21.1
3.8
15 Attachment of F pulse motor
1. Attach the F pulse motor 1 to the FPM holder sub assy. 2 with the 2
screws 1.
2. Attach the lead wire assy, FPM-LE 3 to the F pulse motor 1.
Lubricate the FPM bearing with FBK OIL RO 100.
1-2 drops
XC8388***
1
Torque
0.78 – 1.18 N·m
1
3
2
1
Screw, Bind
M3X4