Brother NS-10 - Attachment of Needle Plate Supporter Shaft B

3 - 60
Feed and bobbin module
Modules
Assembly
10 Attachment of Needle plate supporter shaft B
1. Attach the feed arm supporter 2 to the needle plate supporter shaft B 1.
*Key point
• Check that the hook part 3 of the feed arm supporter 2 is the
lower side.
2. Attach the needle plate supporter shaft B 1 to the base plate assy.
3. Attach the nut 1 M3 4 to the needle plate supporter shaft B 1.
4. Hang the hook part 3 of the feed arm supporter 2 on the base plate assy.
2
3
1
4
3
1