Brother NS-10 - Adjustment

4 - 1
4
Adjustment
Inspection Needle curvature / Tip damage to needle .. 4 - 2
Test Mode Starting test mode................................... 4 - 3
Test mode list.......................................... 4 - 4
Adjustment Adjustment of Timing belt tension........... 4 - 5
Adjustment of Motor belt tension ............ 4 - 6
Adjustment of Upper thread tension ....... 4 - 7
Adjustment of Three point needle drop... 4 - 8
Forward and back adjustment of needle and presser .. 4 - 9
Adjustment of Clearance between
the needle and the rotary hook point .... 4 - 10
Adjustment of Needle bar rise............... 4 - 11
Adjustment of Needle bar height........... 4 - 12
Adjustment of Needle interference left / right 4 - 13
Adjustment of Needle thread block....... 4 - 14
Adjustment of Presser bar height and parallel . 4 - 15
Adjustment of Inner rotary hook (lower thread) tension . 4 - 16
Adjustment of Feed............................... 4 - 17
Adjustment of Bobbin winder ................ 4 - 18
Adjustment of BW switch position......... 4 - 19
Adjustment of BH lever switch position. 4 - 20
Adjustment of Front/back, left/right position of feed dog . 4 - 21
Adjustment of Feed dog height............. 4 - 22
Adjustment of Inner rotary hook bracket position . 4 - 23