Brother NS-10 - Wiring of Bobbin Winder Assy

7 - 10
Special Instructions of Wiring Wiring of bobbin winder assy.
1. Wiring on left side of bobbin winder sub assy.
2. Wiring on front side of main body (right side of main PCB assy.)
Sutter cover
BW lead wire
Pull the BW lead wire from the gap on the side
of shutter cover to the sront side of main body.
Pass the BW lead wire to
the lower side of the FC
lead wire, and then insert
it into the connector of
the main PCB assy.
BW lead wire
FC lead wire
Notch part of the
shutter cover
Push the BW lead
wire to all the way of
notch part.
Main PCB assy.