100
IGNITION SYSTEM
COMPONENT SERVICING
Use Universal Puller Set, P/N 378103, and
Screws, P/N 5034235, to loosen flywheel from
crankshaft.
Install the puller on flywheel with body flat side up.
Seat the shoulder screws completely. Hold puller
by its handle, and tighten pressing screw until fly-
wheel releases.
Remove the flywheel nut, washer, flywheel, and
key.
Disconnect the 6-pin wiring harness connector
from CDI unit.
Remove bolt securing the ignition coil ground
wire.
Disconnect ignition coil lead connectors.
1. Universal puller
2. Screw and washer set
005585
1. Flywheel bolt
2. Washer
3. Flywheel
4. Key
005586
1
2
005587
1. Coil ground lead 005588
1. Ignition coil lead connectors 005589
1
1
1
To Next Page
Loading...
