188
MIDSECTION
STERN BRACKET
Remove two large springs from reverse lock arm
and swivel bracket.
Remove the release arm pin and release link.
Remove cotter pin, washer, pin, and reverse lock.
Remove cotter pin, pin, and reverse lock arm.
Inspection
Inspect all parts for excessive wear, cracks,
defects, or damage. Replace as necessary.
Assembly
Assembly is reverse order of disassembly with
special attention to the following steps:
Apply Nut Lock to threads of shallow drive arm
screws. Install arm and tighten screws 160 in. lbs.
(18 N·m).
Install arm spring as shown.
Apply Triple-Guard grease to clamp bracket shaft
and bushings.
1. Reverse lock springs 005828
1. Release arm pin
2. Release link
005829
1. Cotter pin
2. Washer
3. Pin
4. Reverse lock
5. Cotter pin
6. Pin
7. Reverse lock arm
005830
1. Shallow drive arm
2. Screw
3. Spring
005831
1. Apply grease here 005832
To Next Page
Loading...
