183
MIDSECTION
DRIVESHAFT HOUSING AND OIL PAN
8
Driveshaft Housing/Oil Pan
Install side cover seal with three pins.
Install upper mount screws and washers on steer-
ing bracket.
Install driveshaft housing/oil pan on steering
bracket.
Apply Nut Lock to threads of upper mount screws
and install nuts. Tighten nuts 36 ft. lbs. (50 N·m).
Lower Mount
Assemble the lower side mounts, lower side cush-
ion, and lower thrust mount to lower mount.
Arrow on mount must face forward when installed.
Place lower mount assembly into driveshaft hous-
ing with arrow facing forward.
Install lower mount screw and washer. Apply Nut
Lock to screw threads and tighten nut 46 ft. lbs.
(64 N·m).
1. Pins
2. Cover seal
005782
005781
1. Upper mount nut 005806
1. Lower side mount
2. Lower side cushion
3. Lower thrust mount
4. Lower mount
5. Arrow
005807
005808
To Next Page
Loading...
