BRUEL & KJAER 2525 - Index

Measuring Ampifier Type 2525
User Manual Vol.1
BE1406–12
8–1
Chapter 8
Index
Numerics
15-pole connector ..........................................................2–3
A
Acceleration ...................................................................5–3
Additional filter .............................................................5–6
Alarm .............................................................................5–8
Detector .....................................................................5–9
Hold time ..................................................................5–9
Level ..........................................................................5–9
Level exceed time .....................................................5–9
On/Off ........................................................................5–8
Autorange ......................................................................5–7
Auxiliary connector .......................................................2–3
B
Back-lighting .................................................................4–9
Baud rate .......................................................................4–5
C
Charge floating .............................................................5–4
Charge single-ended .....................................................5–4
Connectors
AC output ..................................................................2–3
Auxiliary ...................................................................2–3
Charge .......................................................................2–2
IEEE ..........................................................................2–3
Preamp output ..........................................................2–3
Serial interface .........................................................2–3
D
Decimal Point ................................................................4–6
DeltaTron .......................................................................5–3
Detector DC output ....................................................5–10
Displacement .................................................................5–3
Display Mode .................................................................4–7
Display Set-up ..................................................... 3–6, 4–2
E
Environment ..................................................................3–2
External filter ...............................................................5–6
F
Fine gain select .............................................................5–4
Force Transducer ..........................................................5–3
Frequency range ...........................................................5–5
Front Panel ...................................................................2–2
G
Gain ...............................................................................5–4
Fine gain select ........................................................5–4
Input gain select ......................................................5–4
Output gain select ....................................................5–5
Ground ...........................................................................2–2
Grounding ......................................................................3–3
H
Handshake ....................................................................4–5
I
Input gain select ...........................................................5–4
Input Type ........................................................... 3–3, 5–3
Inputs .............................................................................2–2
Interface
Connector ..................................................................2–3
Interface Set-up ............................................................4–4
L
Lin./dB Read-out ...........................................................4–3
Linear averaging ...........................................................5–7
Logarithmic averaging .................................................5–6