BRUEL & KJAER 2525 - Page 57

Measuring Ampifier Type 2525
User Manual Vol.2
5–25
BE1394– 11
Chapter 5 – General Control Messages
Error Check and Reset
Error?
The Error? query returns information from the amplifier about the error condition
of the device, where “Error No” is the number of the error, “Err Msg” is a string
containing a short description of the error, and “Log Buffer” contains a string with
the interface message which was executing when the error occurred. If the error
was a device error, the log buffer will be empty.
After the response to the Error? query is sent, the error buffer is reset and Error
No is set to 0. See Chapter 8 for a detailed listing of all interface and device errors.
Example (long):
:Error 1,"Header not found","meas_data:all?^EOI"
Example (short):
:E 1,"Header not found","meas_data:all?^EOI"
Example (off):
1,"Header not found","measurement_data:all?^EOI"
Fig.5.21 Syntax for Error? query and amplifier response
941160e
Te
ERROR?
To 2525
H
eader
OF
f
Te
From 2525
:
Error No
NR1
Err Msg
String (25)
Log Buffer
String (100)
SP
,
,
—
:
ERROR