VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Charging and Battery Maintenance
Charging
Battery should be fully charged before initial use. Optimum battery efficiency will be
achieved after the three full battery charge and discharge cycles.
Follow these steps to hook up and use the charger:
1. Plug the DC connector of the power adaptor into the charger base.
2. Plug the AC connector of the power adaptor into a main AC wall outlet.
3. Place the radio in the charging slot on the charger.
4. For best charging practices, have the radio off while charging.
5. Make sure the radio is making contact with the charger. When the red LED comes on
steady, your radio is charging.
6. The radio is fully charged once the charger's green status LED glows steady. Please
remove the radio at that time to avoid over-charging your battery.
To Next Page
Loading...
